LOGO-L> Multiple Turtles

[George Mills <mills@softronix.com>]

> George,
> 
> I made a figure with several turtles. My current turtle in No. 1. I want
> to connect it with, for instance, turtle 2. Can this be accomplished
> from my position? (I mean, WITHOUT asking explicitly any of the turtles
> about its POS and AFTER it connecting the two points.)
> 
> In other words: What FUNCTION gives me the POS, or HEADING of a turtle,
> while I'm activating another turtle?
> 
> Thanks,
> 

Think like a carpenter. If the tool does not exist to
do the job, then build a tool (a jig) to make it so.

to posturtle :t
localmake "st turtle
setturtle :t
localmake "tp pos
setturtle :st
op :tp
end

You can do distturtle, headingturtle, orientationturtle, towardsturtle
setposturtle, in the same fashion. I could spend a life time expanding
the library.

-- 
===============================================================
George Mills (mills@softronix.com)
http://www.softronix.com/
The www page contains some very powerful educational software.
Our single most important investment is our kids.
---------------------------------------------------------------
Please post messages to the Logo forum to logo-l@gsn.org.  Mail
questions about the list administration to logofdn@gsn.org.  To
unsubscribe send    unsubscribe logo-l    to majordomo@gsn.org.