LOGO-L> How can I save 3d-data?

["Dr. Martin A. Burschka" <Martin.A.Burschka@hkn.de>]

Hi,
We have just started to draw 3d figures with mswlogo and are learning
a lot, even before we have had an opportunuty to lay our hands on any of

the recommended books. The help-facility with the examples is great so
far.

Our problem is that drawing the polygons takes a much longer time than
the POLYVIEW command -- which is where we are learning the most.
So we would like to save the state of the session in sufficient detail
so
that we do not have to restart drawing the polygons.
Saving the bitmap does not seem to help, as the 3d infromation is lost
then.
How do we do this?
We have found the SAVEL-command in the Help but have not been able to
figure out
how to use it for the present purpose.

Thank you for your time!
Christoph and Martin in Germany


---------------------------------------------------------------
Please post messages to the Logo forum to logo-l@gsn.org.  Mail
questions about the list administration to logofdn@gsn.org.  To
unsubscribe send    unsubscribe logo-l    to majordomo@gsn.org.